In our continuing efforts to provide high quality products, Autodesk has released hotfix DL22335805, which addresses an issue where exporting curves to a CAD system, as an IGES file, was not possible from Autodesk® Simulation Moldflow® Insight - Synergy 2014 FCS, Service Pack 1, and Service Pack 2. It also addresses an issue in Service Pack 2, where running an API script to label plots does not allow for the unit to be 'mm'.
This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.
Contents
This hotfix provides the option to export curves to a CAD file as an IGES file, even when the study file contains only curves or surfaces.
The API now works as intended.
This hotfix should only be applied to systems directly affected by the issues described above, as these were the only issues this hotfix was created to address.
For application of this hotfix, your system must have the following product installed:
This hotfix is available in 32-bit and 64-bit versions for Windows. Once installed, it will appear as an update under Add/Remove Programs, and can be uninstalled from there.
We thank all our customers who identified these issues and reported them to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.
Respectfully,
Autodesk Simulation Moldflow Insight Product Team
Copyright © 2013 Autodesk, Inc.