Autodesk®
Fabrication FABmep™ 2013 Service Pack 4
Readme
Thank
you for downloading Autodesk® Fabrication FABmep™
2013 Service Pack 4.
This
readme contains the latest information regarding the installation and use of this
update. It is strongly recommended that you read this entire document before
you apply the update to your licensed copy of Autodesk® Fabrication FABmep™ 2013 software.
For
reference, you should save this readme to your hard drive or print a copy.
Contents
·
Who Should Install
This Update?
·
General Installation
Information
·
Apply This Update to a
Stand-Alone Installation
This update is for the
following Autodesk product running on all supported operating systems. Be sure
to install the correct update for your software.
Product |
Update |
Autodesk® Fabrication FABmep™ 2013 |
Autodesk_Fabrication_FABmep_2013_SP4_x64.EXE (or Autodesk_Fabrication_FABmep_2013_SP4_x86.EXE for 32bit) |
This update can be used with
the following operating systems:
·
Microsoft® Windows® XP Home Edition SP2
·
Microsoft® Windows® XP Professional Edition
SP2
·
Microsoft® Windows® 7 Enterprise
·
Microsoft® Windows® 7 Ultimate
·
Microsoft® Windows® 7 Professional
·
Microsoft® Windows® 7 Home Premium
·
Microsoft® Windows® XP Professional x64
Edition
·
Microsoft® Windows® 7 Enterprise 64-bit
·
Microsoft® Windows® 7 Ultimate 64-bit
·
Microsoft® Windows® 7 Professional 64-bit
·
Microsoft® Windows® 7 Home Premium 64-bit
As you prepare to install this
update, keep the following in mind:
Administrative Privileges
In order to apply this update, you must have administrative privileges to install and uninstall products.
Network Deployment
Special command line switches are available for administrators. The full list can be obtained by running the update with the /? Switch.
/q - Suppresses the completion message after this update is applied. This is useful if you use a script or batch file to apply this update to multiple computers.
/e - Extracts the MSP file from the update executable.
·
Apply This Update
to a Stand-Alone Installation
Follow these instructions to
install this update on a single computer.
1.
Download the update and
save it to any folder.
2.
Close any running instances of Autodesk® Fabrication FABmep™ 2013 software.
3.
Find the folder where
you saved the update and double-click the executable (EXE) file.
4.
When the installation is
completed, the following message will be displayed: "The service pack was
successfully installed and Autodesk Fabrication FABmep™ 2013 has been updated."
Note: This
update cannot be uninstalled to revert Autodesk®
Fabrication FABmep™ 2013 software to its pre-update
state. If you need to remove the update, please uninstall Autodesk®
Fabrication FABmep™ 2013 software and then reinstall
it.
Copyright © 2012
Autodesk, Inc.