In our continuing efforts to provide high quality products, Autodesk has released update DL16445311 which addresses an issue where Runner Balance in Autodesk Inventor Professional 2012 Mold Design does not work with Autodesk Moldflow Advisor 2011 or 2012.
This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.
Contents
Runner Balance in Autodesk Inventor Professional 2012 Mold Design does not work with Autodesk Moldflow Advisor 2011 or 2012
The Runner Balance capability in Autodesk Inventor Professional 2012 requires a valid license and a local installation of Autodesk Moldflow Advisor 2012, or a valid license of Autodesk Moldflow Advisor 2011 and a local installation of Autodesk Moldflow 2011 License Manager. In addition, this Update is required to enable Runner Balance in Autodesk Inventor Professional 2012 Mold Design.
For application of this update, your system must have one of the following products installed:
This update is available in 32bit and 64bit versions (downloaded together as one bundle) and is only applicable to Autodesk Inventor 2012. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.
We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.
Respectfully,
Autodesk Inventor Product Team
Copyright © 2011 Autodesk, Inc.