Notice to Autodesk Inventor Customers: DL17148478 Released

In our continuing efforts to provide high quality products, Autodesk has released update DL17148478 which sets the default Hole termination to "Distance" at the start of an Inventor session, instead of "Through All". The user selected termination type will remain the default selection during that session. It is recommended that this Hotfix only be installed if this is the desired behavior. A more complete solution will be delivered in Service Pack 1 for Inventor 2012. Once the service pack is installed the last user selected termination type will remain the default type from session to session.

This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.

Contents

Return to Top

This Hotfix sets the default Hole termination to "Distance" at the start of an Inventor 2012 session, instead of "Through All". The last user selected termination type will remain the default selection during that session. It is recommended that this Hotfix only be installed if this is the desired behavior. A more complete solution will be delivered in Service Pack 1 for Inventor 2012. Once the service pack is installed the last user selected termination type will remain the default type from session to session.

This update should only be applied to systems directly affected by the issue described above, as this was the only issue this update was created to address.

Return to Top

For application of this update, your system must have one of the following products installed:

Return to Top

This update is available in 32bit and 64bit versions (downloaded together as one bundle) and is only applicable to Autodesk Inventor 2012. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.

Return to Top

We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.

Return to Top


Copyright © 2011 Autodesk, Inc.