In our continuing efforts to provide high quality products, Autodesk has released update DL18139130 which addresses an issue where projected edge will not select as a closed loop for offset.
This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.
Contents
Projected edge will not select as a closed loop for offset
This update should only be applied to systems directly affected by the issue described above, as this was the only issue this update was created to address.
For application of this update, your system must have one of the following products installed:
This update is available in 32bit and 64bit versions (downloaded together as one bundle) and is only applicable to Autodesk Inventor 2012 Service Pack 1. If you do not have Service Pack 1 please download and install prior to installing this Hotfix. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.
We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.
Respectfully,
Autodesk Inventor Product Team
Copyright © 2011 Autodesk, Inc.