Notice to Autodesk Inventor Customers: DL18645508 Released

In our continuing efforts to provide high quality products, Autodesk has released hotfix DL18645508 which addresses an issue where sketch dimension repositioning automatically.

This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.

Contents

Return to Top

Sketch dimension repositioning automatically

This hotfix should only be applied to systems directly affected by the issue described above, as this was the only issue this hotfix was created to address.

Return to Top

For application of this hotfix, your system must have one of the following products installed:

Return to Top

This hotfix is available in 32bit and 64bit versions (downloaded together as one bundle) and is only applicable to Autodesk Inventor 2010 Service Pack 4. If you do not have Service Pack 4 please download and install prior to installing this Hotfix. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.

Return to Top

We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.

Return to Top


Copyright © 2012 Autodesk, Inc.