Notice to Autodesk Inventor Customers

 

In our continuing efforts to provide high quality products, Autodesk has released below hotfix to address the un-translation issue for column headers in the table created for sheet metal flat pattern parts in drawing environment and the issue of German special characters which cannot be displayed properly in the simulation guide document in German Inventor 2013 products.

This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.

Contents

·         Description of the Issue

·         System Requirements

·         Installation Instructions

Return to Top

Description of the Issue

The hotfix is released to correct the un-translation issue for column headers in the table created for sheet metal flat pattern parts in drawing environment and the issue of German special characters which cannot be displayed properly in the simulation guide document in German Inventor 2013 products.

The hotfix should only be applied to systems directly affected by the issue described above, as this was the only issue this hotfix was created to address.

Return to Top

System Requirements

For application of this hotfix, your system must have the following products installed:

·         Autodesk® Inventor® Professional 2013

·         Autodesk® Inventor® 2013

Return to Top

Installation Instructions

1.    Download hotfix “Inventor2013_All Issue_DEU_X86.zip” for 32bit OS or “Inventor2013_All Issue_DEU_X64.zip” for 64bit OS.

2.    Unzip the downloaded file.

3.    Make a backup copy for below .dll file:

It is located in the installation folder of Inventor. Usually, the path is:

……\Autodesk\Inventor 2013\Bin\de-DE

4. Make a backup copy for below .htm file:

It is located in the installation folder of Inventor. Usually, the path is:

……\Autodesk\Inventor 2013\Simulation\Guidance\de-DE\FEA

5. Copy the extracted file to the same installation folder, overwriting the file located there.

Return to Top

Thank You...

We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.

Respectfully,

Autodesk Inventor Product Team

Return to Top


Copyright © 2012 Autodesk, Inc.