Service Pack 1 -for standalone Autodesk Inventor View 2012 (Build 190)

August 19, 2011

Release Notes - Read Me file
Autodesk, Inc.

In a continuing effort to provide high quality products, Autodesk has released this Service Pack 1 for the standalone version of Autodesk Inventor View 2012. This file highlights installation of the service pack.


Return to Top

Return to Top

Installation

    1. Before you install Autodesk Inventor View 2012 Service Pack 1, update your operating system and reboot your system after the updates are installed.
    2. Download either the 32-bit or 64-bit version of Autodesk Inventor View 2012 Service Pack 1, depending upon the bit type of your operating system.
    3. Double click the .msp file to update the standalone version of Autodesk Inventor View 2012 with Service Pack 1. A progress bar displays while the installer updates the files on your system. When done, click Finish.
    4. If required, reboot the system after the service pack installation is finished.

To verify the installation was successful, start Autodesk Inventor View 2012 Service Pack 1. On the Help menu, select About Inventor View. If the About box displays: Build: 190, Release: 2012 SP1, the installation was successful.


Return to Top

Uninstallation

In certain situations, the uninstallation of Autodesk Inventor View 2012 Service Pack 1 through the typical operating system uninstall capability has a dependency on the original installation media. We recommend that before you start this uninstall, ensure the original installation media is available and mounted at the same location used during the installation of Autodesk Inventor View 2012.


The installer process sometimes appears to hang as it waits for operating system file update time-outs. If the following steps do not enable the process to complete, wait until all of these file updates complete. This process can take up to 6 hours. To greatly speed up the uninstall process, perform the following steps:

    1. Access Network Connections from within your systems Control Panel.
    2. Disable the local area connection and all network adaptors, including virtual adaptors.
    3. Once the uninstall process completes successfully, re-enable the local area connection and all network adaptors, including virtual adaptors, from within your systems Control Panel.
    4. If required, reboot the system after the uninstallation of the Service Pack 1 is finished.


Return to Top

Return to Top

Return to Top

Return to Top


Copyright © 2011 Autodesk, Inc.