Creates a kaleidoscope effect. The number, angle and position of the “mirrors” can be controlled, as can the source area for the effect.
Requires an Input (Any).
Produces an Output (Any).
|
Symmetry |
Sets the number of “mirrors”. Set any integer value using the treadmill. |
|
Scale |
Sets the scale of the image. Set any floating-point value using the slider. |
|
Angle |
Sets the angle of the “mirrors”. Set any floating-point value in degrees using the treadmill. |
|
Center X/Y/Z |
Set the centre of the “mirrors” as a normalized proportion of the image. Set any floating-point values using the treadmills. The Z value has no effect. |
|
Offset X/Y/Z |
Set the offset from the original source area as a normalized proportion of the image. Set any floating-point values using the treadmills. The Z value has no effect. By default, the source area is the top-right area of the image. |
|
Interpolate |
Specifies whether or not transformed areas will be smoothed. |
Controls this operator’s Mask Options.
Controls this operator’s Output Options.
Autodesk Softimage v.7.5