The Dark Strokes effect paints the image with diagonal black-and-white brush strokes. Light areas become white and are painted with long strokes that extend into non-white areas. Dark areas become black and are painted with short, tight strokes.
|
Name |
Specifies the operator’s name. |
|
Opacity |
Sets the opacity of the effect over the input image. A value of 0 makes the effect completely transparent, while a value of 100 makes it completely opaque. |
|
Use Alpha As Mask |
Uses the input image’s alpha channel as a mask for applying the effect. The effect is fully applied to areas of the image where the alpha channel is white, and not at all to areas where it is black. |
|
Run Effect On |
Enable the RGB and/or Alpha options to specify whether the effect is applied to the RGB channels, the Alpha channel, or both. |
|
Balance |
The Balance slider changes the proportions of the areas affected by each of the two painting strokes. |
|
Black Intensity |
Set lower values to decrease the intensity of the black painted on the image, or set higher values to increase the intensity. |
|
White Intensity |
Set lower values to decrease the intensity of the white painted in the image, or set higher values to increase the intensity. |
Autodesk Softimage v.7.5