======================================
 Notice to Autodesk Inventor Customers
======================================

In a continuing effort to provide high quality products, Autodesk has released Hotfix TS1104609 which addresses an issue where Virtual Component iProperties are not updated properly. 


================================================================================
CONTENTS
=========

- Description of the issue
- System Requirements
- Warnings
- Installation Instructions


================================================================================
Description of the issues:
=========================

Hotfix - Virtual Component iProperties are not updated properly
 

================================================================================
System Requirements:
====================

Autodesk® Inventor™ Suite 2008
Autodesk® Inventor™ Professional 2008
Autodesk® Inventor™ Simulation Suite 2008
Autodesk® Inventor™ Routed Systems Suite 2008


================================================================================
Warnings:
=========

This hotfix should only be applied to systems directly affected by the issue described above. This is the only 
issue for which this hotfix has been created to address.  


================================================================================
Installation Instructions:
==========================

IMPORTANT! This hotfix is only applicable to Inventor 2008 Service Pack 3. If you do not have Service Pack 3 installed for Inventor 2008 please download and install that before installing
this hotfix.

1. Download Hotfix TS1104609.zip for Inventor 2008 Service Pack 3.
2. Extract Inventor_2008SP3_PS_2008.msp (Inventor 2008 & ProductStream 2008) and Inventor_2008SP3_PS_2009.msp (Inventor 2008 & ProductStream 2009) from TS1104609.zip downloaded in step 1.
3. Double click on the appropriate .msp file (PS_2008 or PS_2009) to install this hotfix on each system running Autodesk Inventor 2008.
4. Chose Next to begin the install.
5. Once finished you'll receive the "Autodesk Inventor 2008 Setup" dialog box stating that the update has been successfully applied.
6. Click Finish to complete the installation and exit the dialog box.  


================================================================================

We want to thank all our customers who identified this issue and reported it to us. It's these reports that give us the opportunity to improve the product and provide 
you, our customers, with the best solution in Mechanical design. Autodesk would also like to take this opportunity to thank you for your continued business and for the
feedback regarding the content of this update release.

Thank you! 

Respectfully,

Autodesk Mechanical Team