In our continuing efforts to provide high quality products, Autodesk has released hotfix TS1105087 which addresses an issue where there are performance challenges with the stress analysis operations.
This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.
Contents
Performance challenges with the stress analysis operations
This hotfix should only be applied to systems directly affected by the issue described above, as this was the only issue this hotfix was created to address.
For application of this hotfix, your system must have one of the following products installed:
This hotfix is available in 32bit and 64bit versions (downloaded together as one bundle) and is only applicable to Autodesk Inventor 2010. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.
We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.
Respectfully,
Autodesk Inventor Product Team
Copyright © 2009 Autodesk, Inc.