Notice to Autodesk Inventor Customers: TS1109767 Released

In our continuing efforts to provide high quality products, Autodesk has released hotfix TS1109767 which addresses an issue where C++ project for Publishing DWF will reset the options in UI.

This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.

Contents

Return to Top

C++ project for Publishing DWF will reset the options in UI

This hotfix should only be applied to systems directly affected by the issue described above, as this was the only issue this hotfix was created to address.

Return to Top

For application of this hotfix, your system must have one of the following products installed:

Return to Top

This hotfix is only applicable to Autodesk Inventor 2008 Service Pack 3. If you do not have Service Pack 3 installed for Inventor 2008 please download and install prior to installing this hotfix. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.

Return to Top

We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.

Return to Top


Copyright © 2009 Autodesk, Inc.