Notice to Autodesk Inventor Customers: TS1110047 Released

In our continuing efforts to provide high quality products, Autodesk has released hotfix TS1110047 which addresses an issue where the user needs the ability to set a different unit as "cm" for sheet metal properties.

This document contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your product. For reference, you should save this document to your hard drive or print a copy.

Contents

Return to Top

User needs the ability to set a different unit as "cm" for sheet metal properties

This hotfix should only be applied to systems directly affected by the issue described above, as this was the only issue this hotfix was created to address.

Return to Top

For application of this hotfix, your system must have one of the following products installed:

Return to Top

This hotfix is available in 32bit and 64bit versions (downloaded together as one bundle) and is only applicable to Autodesk Inventor 2010 Service Pack 2 for the Subscription Bonus Pack. If you do not have Service Pack 2 for the Subscription Bonus Pack please download and install prior to installing this Hotfix. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.

Return to Top

The following two workflows will allow the user the ability to change the units in new sheet metal parts and existing parts after installing this hotfix.

NEW MODEL

EXISTING MODEL

Return to Top

We thank all our customers who identified this issue and reported it to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.

Return to Top


Copyright © 2009 Autodesk, Inc.