Autodesk®
TS1110830 - Autodesk Vault 2011 - Localization Check Out Hotfix

In a continuing effort to provide high quality products, Autodesk has released this hotfix which provides a check out update
for non English product versions.

This README file highlights how to install this hotfix and other important information regarding this update.

CONTENTS

Description of the Issue
System Requirements
Related Hotfixes and Utilities
Known Issues
Warnings
Files Affected
Update Verification
Installation Instructions

Description of the Issue

On new installations of non English product versions a file check out will fail. This does not occur on upgrade installations.

System Requirements


  • Autodesk Data Management Server 2011 Update 1 (Vault)
  • Autodesk Data Management Server 2011 Update 1 (Workgroup)
  • Autodesk Data Management Server 2011 Update 1 (Collaboration)
  • Autodesk Data Management Server 2011 Update 1 (Professional)

  • Related Hotfixes and Utilities



    Known Issues



    Warnings


    It is strongly recommended to perform a back up prior to the application of this update.

    This hotfix cannot be uninstalled. To revert to a pre-hotfix state, a restore of a previous back up must be performed.


    Files Affected


  • Connectivity.ProductStream.dll
  • Connectivity.Vault.dll

  • Update Verification

  • The updated files are version 15.1.58.40.
  • Installation Instructions


    WARNING: Failure to follow these instructions properly may result in unusable sites. This procedure applies to
    Single Site, Multi Site and Connected Workgroup deployments.

    NOTE: Always ensure that a successful backup has been performed before applying any hotfixes.

    Hotfix Installation – applied to every Autodesk Data Management Server (ADMS).

    1. Open the ADMS Console.
    2. Make sure all databases are fully migrated to the latest version.
      1. Migrate all unmigrated databases and libraries before proceeding.
    3. Close the ADMS Console application.
    4. Reset the web service by typing 'iisreset' at the command prompt.
    5. Run TS1110830.msp on the ADMS server to install the hotfix.
    6. Repeat the preceding steps for every ADMS server.


    Database Update – applied ONCE from one Autodesk Data Management Server (ADMS) instance as specified.

    1. WARNING: DO NOT PROCEED until the hotfix has been successfully applied on ALL ADMS servers.
    2. Use one instance of the ADMS Console on:
      1. Single Site
      2. Multi Site (file replication)
      3. Connected Workgroup (file and SQL replication) on a Publisher Workgroup ONLY
    3. Reset the web service by typing 'iisreset' at the command prompt.
    4. Open a command prompt and navigate to the installed location of Connectivity.ADMSConsole.exe.
    5. Run ADMS b2bmigrate operation in command line mode:
      1. Example: Connectivity.ADMSConsole.Exe -Ob2bmigrate -VUadministrator -VPadmin_password -DBUsql_user -DBPsql_password
      2. NOTE: Replace 'admin_password' with the appropriate administrator password for the -VP switch.
      3. The last two command line parameters are required only if the 'sa' password is not the default password.
    6. A 'migration successful' dialog will display when the b2bmigrate operation has completed.


    Copyright © 2010 Autodesk, Inc.